Exposure data on biocides are relatively rare in published literature, especially for secondary exposure. This is also the case for antifouling exposure. Therefore, a field study was carried out measuring exposure to antifouling paints. Both primary exposure (rolling and spraying) and secondary exposure (during sand blasting) were studied. Exposure during rolling was measured in boatyards where...

A comprehensive investigation was carried out to minimize the cost price of the rock fragmentation process including: drilling, blasting, secondary blasting and separating the large boulders (oversize rocks) while loading, until the optimized fragmentation, powder factor and ratio of burden (B) to blasthole diameter (?h) were achieved by doing several stages of drilling and blasting practically...

Correct selection of coefficients for blasthole parameters in Ghalat limestone mine in Shahr-e-kord of Iran has resulted is designing and performing 20 blasting operations. After each blast, fragmented rocks larger than one square meter, called oversize, are estimated and prepared for secondary blasting. Next blasthole pattern were designed based on previous blasting results. The results of the...

Dry-ice particle blasting is similar to sand blasting, plastic bead blasting, or soda blasting where a media is accelerated in a pressurized air stream (or other inert gas) to impact the surface to be cleaned or prepared. With dry-ice blasting, the media that impacts the surface is solid carbon dioxide (CO2) particles. One unique aspect of using dry-ice particles as a blast media is that the pa...

The controlled presplitting blasting technique is widely used in mining engineering to improve the permeability and gas extraction efficiency of coal seams. One of the key factors is the appropriate arrangement of the blasting and drainage holes, which can help improve the gas drainage quantity. To optimize the drilling layout to enhance gas-drainage efficiency, a series of controlled presplitt...

Trial blasting is conducted to identify the characteristics of the blasting of the applicable ground before production blasting and to investigate various problems posed by blasting. The methods and pattern of production blasting are determined based on an analysis of the results of trial blasting. The bedrock in Jeju Island, South Korea is formed through the volcanic activities unlike the inla...

In order to understand the stress changes of various points in sandy frozen soil, tension-compression conversion, fissure development on the surface, the rupture process, the expansion speed and scope of frozen soil duing blasting, the dynamic characteristics of thin-layered sandy frozen soil were analyzed in this paper. The blasting process of frozen soil is regarded as a dynamic pressure oper...

OBJECTIVE Polyaxial pedicle screws are a safe, useful adjunct to transpedicular fixation. However, the large screw head size can cause soft tissue irritation, high rod positioning, and facet joint injury. However, the mechanical resistance provided by small and low profile pedicle screws is very limited. We therefore developed a novel, low profile pedicle screw using grooving and blasting treat...

Estimating the costs of blasting operations is an important parameter in open-pit mining. Blasting and rock fragmentation depend on two groups of variables. The first group consists of mass properties, which are uncontrollable, and the second one is the drill-and-blast design parameters, which can be controlled and optimized. The design parameters include burden, spacing, hole length, hole diam...

Adhesion strength of exterior or interior coating of steel pipes is too important. Increasing of coating adhesion on surfaces can increase the life time of coating, safety factor of transmitting line pipe and decreasing the rate of corrosion and costs. Preparation of steel pipe surfaces before doing the coating process is done by shot and grit blasting. This is a mechanical way to do it. Some e...